Preparing for Winter (in Autumn)

On average, 20% of unmanaged bee colonies may die during winter. In managed hives this figure can vary from around 5% to 100%, depending on the measures taken in autumn to prepare for winter.

The prime consideration for over-wintering bees is to keep them alive and in reasonable condition to come into the spring. If they survive into spring, their numerical strength and disease status will largely depend on what management practices were adopted in autumn, not what is done in winter. In fact, as little as possible should be done during winter as manipulation during this time may undo all precautions taken in previous months. An exception to this is if your hives are on a winter honey flow.

Winter hive preparation is all about reducing space, defending against intruders and making sure bees have enough honey in stock.

Packing down and winterising your hives ensures that bees aren’t wasting energy heating large unused spaces and are protected from the elements. Installing robbing screens and excluders is another step, helping keep pests and predators out of the hive while it’s at its weakest. It’s also important to know how to store the hive boxes and frames that you remove to prevent loss to pests.

Reduce Hive Volume

In spring and summer, bees need ample space to expand their population and store as much honey as possible in preparation for winter. In winter, the colony shrinks and much of the honey is consumed. The remaining bees cluster in the centre of the hive, vibrating their wings to stay warm but otherwise moving around very little. This means all that excess space in the hive is a burden as bees consume more honey to heat and defend it.

Reduce the size of your hives at harvest time by removing honey supers – don’t put them back on until next spring. You should be left with a two-box hive, with the brood box on the bottom and the full honey super on top. Remove empty brood frames, and make sure there are two to four full honey and pollen frames in the brood box so your bees have easy access to food.

It’s also most important to remove any queen excluders, so the Queen can travel freely between boxes.

Reduce Hive Entrance

The colony is at its weakest during winter, making it vulnerable to robbing, wasps, beetles, mice and other invaders. Adding a robbing screen can help keep wasps and bees from other colonies out by screening the main hive entrance, while a Mouse Guards can prevent rodent entrances.

Winterproofing

Place hives on blocks or a Stand so they are about 30cm above ground away from cold ground temperatures. If it’s extremely cold, you could add an Insulated Hive Cover for extra warmth. If the area is stormy or your property is exposed to strong winds, move hives to a sheltered location and secure them so they won’t be blown over.

Winterising Unused Equipment

Drawn comb is at risk of being eaten by moths, mice and other pests; so keep it safe by:

• Freezing drawn comb frame for at least 48 hours at -25^oC to kill any moth eggs or larvae on the frames or in the comb.
• Store in an airtight container or large plastic bag, and place in a cool, dry spot; and then
• Place frames in rodent-proof sealed container.

Winter Inspections

Lift the cover for short periods on warm days infrequently practical.

• Honey in the hive;
• Numerical strength;
• Disease status;
• Location and site of apiary;
• Ventilation;
• Hive entrance;
• Supplementary feeding.

Pre-winter inspection

The final inspection before the onset of winter should take place in April or the beginning of May at the latest.

Pick a sunny day on the warmer side, and remove the lid and any supers. In doing so, estimate the amount of honey stored. Thoroughly inspect the brood for disease symptoms and, at the same time, check the status of the colony and Queen:

Is there a drone layer?

Is it a weak colony or is the Queen failing, or is it a colony with a good population headed by a young Queen?

Queens and numerical strength

These factors are of prime importance. If the Queen is failing, or has become a drone layer, or the colony is Queenless, then forget about over-wintering that hive. Kill the Queen and join with another colony, placing a piece of newspaper between them. If the Queen cannot be located, then let the colony die out. Joining it onto a Queen-right colony may lead to that colony’s downfall as well.

If the colony has insufficient bees (less than six frames of bees) to maintain a cluster and thus preserve the temperature in the hive, it may easily succumb to cold weather and die. It is important that nucleus hives made up after Christmas are sufficiently strong. This can be achieved either by joining with another colony (one Queen must go) or by transferring a frame or two of brood with bees (no Queen) into the weaker colony without seriously debilitating the hive from which the brood is removed.

This practice is to be avoided in the late autumn as excess manipulation will put the bees under undue stress. If the colony hasn’t built up by late March, then something is amiss with the Queen or colony – due to either low fertility or disease, or lack of pollen and nectar.

Disease status

Four brood diseases may be encountered:

• European Foulbrood
• American Foulbrood (AFB)
• Sacbrood
• Chalkbrood.

A colony confirmed to have American Foulbrood (AFB) must be destroyed after contacting your nearest apiary inspector. If a colony has a trace of European Foulbrood (EFB), treatment with antibiotics is recommended.

Medication may not work satisfactorily in a colony which is heavily infected.

On the other hand, Sacbrood is only a minor disease. Serious cases are uncommon but at times Sacbrood can be confused with AFB and EFB. Chalkbrood reduces production by killing some of the developing brood. Treatment with medications is not possible. Nosema, a disease of adult bees, is particularly significant in an over-wintering situation. Nosema is associated with stress through nutrition deficiencies and manipulation. Management techniques rather than medication are used to control this disease. These techniques are more or less similar to those practices used for over-wintering bees.

When the brood nest has been examined, close the hive up. Note the reserves of honey the colony has for winter.

Stores

More colonies die from starvation than from any other cause during winter. In determining how much honey to leave on a hive we must also assess how much there is. Colonies should be reduced to doubles (two boxes) and, if strong in numbers, should have one box nearly full of honey.

If the colony is on the weaker side, it is desirable to over-winter the colony in a brood box as a single deck hive. The colony should have three or four frames full of honey. If you are unsure It is always better to leave too much honey rather than too little. Avoid feeding liquid honey back to bees, due to the possibility it is carrying bee disease organisms.

The alternative is to feed sugar in syrup form, see Beewise ProSweet. If this method is selected, it is better to feed in bulk before winter than to feed in small lots through winter. Brown, raw or any other similar sugars are not suitable and will lead to digestive problems if fed to bees.

A ration of Beewise ProSweet or 2:1 sugar:water is recommended for winter stores. Up to 10L of Beewise ProSweet or 10kg sugar may be fed to each hive as small amounts tend to stimulate the colony, a situation to avoid at this time of the year.

When determining how much carbohydrate to feed, as a guide 2.5L Beewise ProSweet or 2.5kg of sugar is equal to one frame of honey.

Examples of commercial and hobby feeders are shown via: Bee Feeders

Take care not to leave fermented syrup in the feeders. If bees haven’t consumed the syrup within 3 days, discard the syrup.

Location and site of the apiary

The siting of an apiary, important at any time of year, is of particular concern during cooler months. Wind can devastate bee populations in the winter. Wind whistling through the hive will place the hive under a lot of stress, causing the colony to consume its stored honey very quickly and increasing the level of disease, particularly Nosema.

Locate your hives in a dry sunny area, preferably with a north-east aspect and protected from prevailing winds. This will ensure the maximum number of cleansing flights, which will help to keep Nosema at a low level. Bees confined for a long time foul their hive, leading to high levels of Nosema.

Hives in coastal areas are more inclined to rear brood through the winter. These warmer areas encourage bees to forage all winter, thus requiring a higher level of management. A close check should be kept of stored pollen, Nosema levels, and the amount of brood.

Livestock should also be considered when selecting a site. Cattle have a habit of using hives as a convenient rubbing post, usually pushing the hives over.

Other factors to consider

• It is often an advantage to reduce the entrance to 50–75 mm. This will allow weaker colonies to guard their entrance more effectively.
• Winter months are often wet and vehicle access to the site can be a problem. Take this into consideration when choosing a position to overwinter bees.
• Remember that the best time for over-wintering preparation is autumn. Confine your bee-related winter activities to your garage or workshop, preparing and repairing equipment for the coming spring.
• If you wish to check on the progress of colonies during winter, choose a warm sunny day. You should visit your hives once a month and lift them up by the back hand hole to check their weight.
• Remember, when bees start to increase the brood area towards the end of winter, starvation is the greatest problem.